#21
|
|||
|
|||
Re: hfs6 problems
ok rich, is that the only thing i have to do, and then the system will work properly?
|
#22
|
|||
|
|||
Re: hfs6 problems
hey rich, i connected those two wires and i'm not getting any spray using the test jumper. am i missing something?
|
#23
|
|||
|
|||
Re: hfs6 problems
send as picture of your connection work.
__________________
Richard L aquamist technical support |
#24
|
|||
|
|||
Re: hfs6 problems
will do. basically, i crimped that brown wire to a new wire and soldered it onto the coil (the wire on it, was not long enough).
i tested all the voltages and it's getting voltage. i also manually jumped a ground wire to the coil just to make sure the valve was not dead and it indeed does spray out. |
#25
|
|||
|
|||
Re: hfs6 problems
If you use the TST to activate the system. The other jumper link must be on IDC.
__________________
Richard L aquamist technical support |
#26
|
|||
|
|||
Re: hfs6 problems
Quote:
the car was tuned yesterday, with all the jumpers etc set as if it would be tuneable, but nothing happened. there's a fault somewhere. should all the RJ connections have a green light lit? |
#27
|
|||
|
|||
Re: hfs6 problems
Time for a new system?
__________________
Richard L aquamist technical support |
#28
|
|||
|
|||
Re: hfs6 problems
at this point, it points that way correct? is there any way i can buy parts and convert this one to say an HFS3? i mean, the pump wiring is the same, the gauge is the same, the power supply is the same. i would need the control box and injection box.
|
#29
|
|||
|
|||
Re: hfs6 problems
None of the connectors are the same. It will be a mess if you to it this way. You can get the H3 system from me minus the pump. Email me.
__________________
Richard L aquamist technical support |
|
|