#1
|
|||
|
|||
F13 M6 hfs 3 post install questions
I haven’t adjusted any of the settings out of the box for the hfs3 unit. Chose to hook it up via map sensor (boost via just blue and red cables) instead of injector pulse (green). I Turned on the vehicle no leaks. Gauge shows S and led lit green in the back. However under wot I am not seeing the blue bars on the gauge light up. Any recommendations for troublshooting?
|
#2
|
|||
|
|||
Re: F13 M6 hfs 3 post install questions
Just an update, I did not wire the injectors to the system as I am running this off boost (map) and have that wired. Do I still need to wire the direct injection system to have this system running?
|
#3
|
|||
|
|||
Re: F13 M6 hfs 3 post install questions
If you run boost only, you need to solder link MPS on the underside of the circuit board and cut IDC.
Also move jumper link from iDC to MPS
__________________
Richard L aquamist technical support |
#4
|
|||
|
|||
Re: F13 M6 hfs 3 post install questions
Thank you for the response will get on that ASAP!
|
|
|